Sharp KH-6I27CS00 -EU Gebrauchsanweisung Seite 62

keep-warm function has been activated, the
corresponding display will show 'u'.
The above image shows the front right
heater display indicating the keep-warm
function.
Chocolate-Melting Function
This function melts chocolate or similar
foods at around 40°C. To activate the
chocolate-melting function, press the
heater selection button five times. When
the chocolate-melting function has been
activated, the corresponding display will
show 'c'.
In the image above, the front right heater
display is indicating the chocolate-melting
function.
Performance and time may vary
according to the quantity of food in the
pan and the quality of the pan. 1.5
litres of water or 0.5 litres of oil gives the
best cooking performance with these
functions.
If there is an error, an error code will be shown on the
E1 Cooling Fan is disabled. Call an authorised
E3 Supply voltage is other than the rated values.
Switch the hob off by pressing
"H" disappears for all zones, switch the hob
on by pressing
the same error is displayed again, call an
E4
Supply frequency is different from the rated
values. Switch the hob off by pressing
zones, switch the hob on by pressing
and continue to use. If the same error is
displayed again, switch the plug for the
appliance off and on. Switch the hob on by
pressing
error is displayed again, call an authorised
E5 Internal temperature of the hob is too high,
switch the hob off by pressing
E6 Communication error between the touch
control and heater. Call an authorised service
E7
Coil temperature sensor is disabled. Call an
E8 Cooler temperature sensor is disabled. Call
EA Large Coil Saturation Error. Switch the hob
off by pressing on/off button, switch the hob
on by pressing on/off button and continue to
use. If the same error is displayed again, call
EC Supply Voltage Error.Switch the hob off by
pressing on/off button, switch the hob on by
pressing on/off button and continue to use.
If the same error is displayed again, call an
C1-C8 Mcroprocessor alert. Switch the hob off by
pressing on/off button, switch the hob on by
pressing on/off button and continue to use.
If the same error is displayed again, call an
The Vitroceramic Glass Spatula
Always use the glass spatula to remove
spillages or deposits from the hob before
trying chemical cleaning agents. This is
the ideal method for removing even the
smallest deposits from the hob, and for
removing spillages from hot cooking zones
before they burn onto the hob.
Important: Always push the safety
cover back over the razor blade after use.
Take care when using the spatula and keep
it out of the reach of children.
EN - 18
Error Codes
heater displays.
service agent.
and continue to use. If
authorised service agent.
, wait until "H" disappears from all
and continue to use. If the same
service agent.
heaters cool down.
agent.
authorized service agent.
an authorized service agent.
an authorised service agent.
authorised service agent.
authorised service agent.
Accessories
,wait until
and let the