Sharp KH-6I27CS00 -EU Gebrauchsanweisung Seite 61

While the hob is in operation, the following
activities will be signalled by the buzzer.
• Normal button activation will be
accompanied with a short sound signal.
• Continuous button operation over a
longer period of time (10 seconds)
will be accompanied with a longer,
intermittent sound signal.
Boost Function
To use this function, select a cooking zone
and set the desired cooking level, then
press the "P" (Boost) button.
The Boost function can only be activated
if it is applicable with the cooking zone
selected. If the Boost Function is active,
a "P" will be shown on the corresponding
display.
Activating the booster can exceed the
maximum power, in which case the
integrated power management will be
activated.
The necessary power reduction is shown
by the corresponding cooking zone display
blinking. Blinking will be active for 3
seconds to allow for further adaptations of
the settings before power reduction.
Bridge Zone
Switching the Bridge Zone On
Touch the front left and rear left heater
selection buttons simultaneously. A static
dot will be shown on the left heater display.
The other displays will show 'b' and 'r', the
blinking dots will no longer be displayed.
Select the temperature setting by using the
sliding button. Increase the heat setting by
pressing the right side of the sliding button
or decrease the heat setting by pressing the
left side of the sliding button.
The bridge element will be ready to use.
For the fastest boil time, select the desired
cooking level, then press the "P" key to
activate the Boost function.
Switching the Bridge Zone off
To select the Bridge element, press the rear
left or front left heater selection button and,
using the left side of the sliding button, turn
the level down to "0". If the bridge cooking
zone is hot, "H" will be displayed.
Special Cooking Modes
Press and release the heater selection
button to cycle through the boiling, frying,
keep-warm and chocolate-melting special
cooking functions. Special cooking
functions are only available on the right side
of the hob. Boiling and frying cannot be
selected simultaneously until after one beep
is heard from the hob.
Boiling Function
This function is used to boil water and
keep the temperature close to boiling point.
To activate the boiling function, press the
heater selection button twice. When the
boiling function has been activated, the
corresponding display will show 'b'. The
hob will beep to indicate when the water
has boiled and the water will then simmer.
The above image shows the front right
heater display indicating the boiling
function.
Frying Function
This function will fry oil at around 160°C.
To activate this function, press the heater
selection button three times. When the
frying function has been activated, the
corresponding display will show 'F'.The hob
will beep when the oil is ready for frying.
In the image above, the front right heater
display is indicating the frying function.
Keep-Warm Function
This function allows the temperature of
food to be kept at around 50°C. To activate
the keep-warm function, press the heater
selection button four times. When the
EN - 17