General Power Tool Safety Warnings; Work Area Safety - Parkside PFMRA 20-Li A1 Originalbetriebsanleitung

OUTPUT
Rated voltage
Rated current
Charging time
Protection class
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise and vibration data
Noise measurement value determined in accordance
with EN 62841. The A-rated noise level of the power
tool is typically:
Noise emission value
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear ear muffs!
Total vibration value
Handle
Uncertainty
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with ano-
ther tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the pow-
er tool is being used, and in particular the
kind of workpiece that is being worked, the
vibration and noise emission values can devi-
ate from the values given in these instructions
during actual use of the power tool.
PFMRA 20-Li A1
21.5 V (DC)
4.5 A
approx. 60 min
II / (double insulation)
L = 80.8 dB (A)
PA
K = 3 dB
PA
L = 91.8 dB (A)
WA
K = 3 dB
WA
a = 3.2 m/s
h
K = 1.5 m/s
WARNING!
► It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use (all
states of operation must be included, e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, illust-
rations and specifications provided with this
power tool. Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury.
2
Save all warnings and instructions for future
reference.
2
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive at-
mospheres, such as in the presence of flam-
mable liquids, gases or dust. Power tools crea-
te sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ MT │
45 ■