Electrical Installation - SICK WTS26 Betriebsanleitung

OPERATING INSTRUCTIONS
4 Mounting
en
5

Electrical installation

28 O P E R A T I N G I N S T R U C T I O N S | WTS26
WTS26x-xxxxxx30
1
2
4 3
BluePilot blue: sensing range display
1
Press-turn element / Potentiometer / Teach-Button: adjusting the sensing range
2
Yellow LED: status of received light beam
3
Green LED: supply voltage active
4
Press-turn element: time function adjustment
5
Teach pushbutton: adjustment of light/dark switching
6
Mount the sensor using a suitable mounting bracket (see the SICK range of accesso‐
ries).
Note the preferred alignment of the sensor relative to the movement direction of the
object, see figure 1.
Figure 1: Alignment of the sensor relative to the object direction
Note the sensor's maximum permissible tightening torque of < 1.3 Nm.
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Note pin assignment
– Cable: wire color
Only supply/switch on the voltage once all electrical connections have been estab‐
lished.
Explanations of the connection diagram (following tables):
Alarm = alarm output
WTS26x-xxxxxx31
6
1
2
4 3
WTS26x-xxxxxx32
5
1
2
4 3
8020355.1GI9/2022-07-13 | SICK
Subject to change without notice