Bresser WIFI WSC PRO 7in1 Bedienungsanleitung Seite 10

PLASTIC MOUNTING INSTALLATION
1. Fasten the plastic pole onto your fix pole with mounting base, clamp, washers, screws and
nuts. Following below 1a, 1b, 1c sequences:
1a. Insert the plastic pole into the hole of the
mounting stand, and then secure it with the screw
and nut.
1b. Apply 2 rubber pads on the mounting clamp.
2. Apply 2 rubber pads on the inner
sides of the mounting base and
clamp of the sensor-array, and
loosely fasten them together.
1c. Fasten the mounting stand
and clamp together onto a fix
pole with 4 long screws and
nuts.
3. Place the sensor-array over the mounting pole
and align it to North direction before fastening the
screws.
10