Cameo AZOR S2 GOBOS Bedienungsanleitung

USER MANUAL
AZOR S2 GOBOS
®
COMPACT SPOT MOVING HEAD - GOBO
NOTES ON GOBOS AND GOBO REPLACEMENT
These installation instructions do not replace the user manual of the associated product!
The gobos in gobo wheel 1 of the spotlight are interchangeable. Below are images of the gobos in both gobo wheels.
ATTENTION:
Gobos may only be replaced by qualified specialist personnel. If you are not qualified to do this, do not try to replace gobos yourself. Refer instead to professional companies.
GOBO WHEEL 1, ROTATING GOBOS
Gobo 1 Gobo 2
GOBO HOLDER FOR ROTATING GOBOS
GOBO WHEEL 2, FIXED GOBOS
SUBJECT TO MISPRINTS AND ERRORS, AS WELL AS TECHNICAL OR OTHER MODIFICATIONS!
Gobo 3 Gobo 4
Retaining spring
Gobo
Gobo holder
Cameo ® is a registered brand of the Adam Hall Group
Adam Hall GmbH | Adam-Hall-Str. 1 | 61267 Neu-Anspach | Germany
Phone: +49 6081 9419-0 | adamhall.com
Gobo 5 Gobo 6
ALIGN THE GOBO CORRECTLY
When replacing a gobo, make sure that the gobos are inserted in the corresponding holder in the
correct orientation and that there is sufficient heat resistance; otherwise heat damage to the gobos
and gobo holders may occur. For proper orientation of the gobo, refer to the drawings and descrip-
tions below. However, if there is any doubt about the orientation and heat resistance of a particular
gobo type, please contact the gobo manufacturer.
COATED GLASS GOBO
Insert a coated glass gobo into the correspon-
ding gobo holder so that the more reflective
side of the gobo faces the light source. The less
reflective side of the gobo absorbs less heat
in this way.
GLASS GOBO WITH SURFACE STRUCTURE
TECHNICAL DATA
Product type: Gobo wheel 1, rotating gobos
Outer Ø: 16.5 mm (+0 / - 0,2)
Ø motif: 10.5 mm (+0 / - 0.2)
Material: Borosilicate glass
Material thickness 1.1 mm
Heat resistance: 600°C
Gobo 7 Gobo 8
TEXT OR GRAPHIC GOBOS MADE OF METAL
Gobos with a defined orientation (e.g. text
gobos) are correctly displayed in the projection
if they are correctly displayed when viewed
from the side facing the light source.
Glass gobos with surface structure are gene-
rally aligned with the structured side towards
the light source. In most cases, the gobo is
glued into the gobo holder with the help of a
heat-resistant special adhesive, as the uneven
surface prevents secure installation with a
retaining spring.