INVENTOR N2UVI-09WFI Benutzerhandbuch Seite 11

ECO/GEAR function
ECO operation:
Under cooling mode, press this button, the remote controller will adjust the temperature
automatically to 24 C/75 F, fan speed of Auto to save energy (only when the set temperature
O
is less than 24 C/75 F). If the set temperature is above 24 C/75 F, press the ECO button,
O
the fan speed will change to Auto, the set temperature will remain unchanged.
NOTE:
Pressing the ECO/GEAR button, or modifying the mode or adjusting the set temperature to less
than 24 C/75 F will stop ECO operation.
O
O
Under ECO operation, the set tmeperature should be 24 C/75 F or above, it may result in
insufficient cooling. If you feel uncomfortable, just press the ECO button again to stop it.
GEAR operation:
Press the ECO/GEAR button to enter the GEAR operation as following:
75%(up to 75% electrial energy consumption)
50%(up to 50% electrial energy consumption)
Previous setting mode.
Under GEAR operation, the display on the remote controller will alternage between
electical energy consumption and set temperature.
Press this button to enter the energy efficient mode in a sequence of
following:
ECO GEAR(75%)
Note:This function is only available under COOL mode.
O
O
GEAR(50%) Previous setting mode
O
O
O
O
11
ECO......