Setup And Operation; Mounting The Feedline To The Dispenser; Mounting The Feedline To The Applicator - Loctite 98548 Bedienungsanleitung

4

Setup and Operation

4.3 Setup and Operation
4.3.1

Mounting the Feedline to the Dispenser

• As shown in the right graphic,
lift guide lock 10 and release
tube guide 11.
• Put the tube into the groove of the
right tube holder 13.
• Place the tube directly on the rollers.
• Put the tube into the groove of the left
tube holder 13.
• Press the white guide plate of tube
holder on both sides carefully against
tube and fix it with the locking knob.
• Pay attention that the tube is placed directly on the rollers.
The tube is guided and held in place with the tube holder 13.
• Slowly close the tube guide 11 while turning the rotor manually.
☞
If the tube guide is tightened without turning the rotor, the shape of the rotor will be
impressed and the tube will not be inserted evenly.
Always turn the rotor while closing the tube guide.
• Secure the tube guide 11 by following the 1
If a thick tube is inserted and the rotor
stops,
• Lift guide lock 10.
• Unscrew the bigger lock grip from the
smaller one.
• Turn the screw counterclockwise one
revolution.
• Assemble both lock parts.
• Close the tube guide 11 as described above and start dispensing.
If product is not dispensed and the rotor stops again repeat steps above with a turn of
½ revolution counterclockwise. Repeat the steps till product is dispensed.
Pay attention that it is possible product is not dispensed and the rotor does not stop
then call the last step off.
4.3.2

Mounting the Feedline to the Applicator

• Mount the applicator nozzle 17, which
corresponds to the used tube.
• Stretch the tube to reduce diameter.
• Cut the tube and press the remained
deformation together.
• Pull the tube through the applicator.
st
instruction step in reversed order.
m
0 m
~ 7
9