Cleaning; Troubleshooting - Instarter Spectar Rgb Led Panel 5.0 Gebrauchsanleitung

7. Open the fixing screw of the holder (4) and lift the luminaire off the
tripod.
8. Store the luminaire and the accessories in the transport bag and, if
necessary, in the article packaging.
NOTE - Always store the luminaire in a dry and dust-free place.
9.

Cleaning

NOTE - Only clean the components as indicated in the table below.
Never allow the luminaire or the power supply unit to come into contact
with moisture or water.
Component
Housing, diffuser,
screening covers
Lamps
NOTE - Do not use any cleaning agents or solvents! Make sure that no
moisture enters the housing!

10. Troubleshooting

Problem
Luminaire is switched
on but shows no
function
38
Cleaning
1. Remove dirt with a dry or damp soft
cloth (non-fluffy, e.g. microfibre cloth).´
2. Allow parts to dry completely.
Dab with a dusting brush or dry,
soft anti-static cloth.
Possible causes
Mains cable is not
plugged in or not
plugged in correctly
Batteries are not
inserted
Batteries are empty
Remedy
Connect power supply
correctly
Insert batteries
Charge batteries