Setting The Brightness / Dimmer On The Luminaire; Adjusting Colour Temperature, Rgb Colour, Colour Saturation And Effects On The Luminaire - Instarter Spectar Rgb Led Panel 5.0 Gebrauchsanleitung

6. Slide the diffuser (2) from above into the retaining rails of the housing.
→ Pay attention to the alignment!
7. Close the holder (1) again.

7.5 Setting the brightness / dimmer on the luminaire

1. Switch on the luminaire as described in the chapter 6 .
2. Turn the rotary knob (6) to the right or left until the desired brightness is
reached.
→ The selected % value is shown in the display (10). The setting range
is 1-100%.
7.6 Adjusting colour temperature, RGB colour, colour saturation and
effects on the luminaire
Use the function knob (7) to set the colour temperature (7500 K), the colour
(H 360°), the colour saturation (S 100) and the light effects (effect 01
1. Switch on the luminaire as described in the chapter 6 .
2. Press and hold the function knob (7), until the desired function is shown
in the display, then release.
Colour temperature 3,200-7,500 K:
3. Turn the function knob (7) to the right or left until the colour temperature
corresponds to your idea.
→ The corresponding colour temperature in K is shown in the bottom
line of the display (10).
RGB colour 0-360°:
4. Turn the function knob (7) to the right or left until the colour corresponds
to your idea.
→ The corresponding colour (H) in ° is shown in the bottom line of the
display (10).
36
– 09).