Commissioning; Mounting The Luminaire On A Tripod; Power Supply Via Mains Adapter; Power Supply Via Rechargeable Battery - Instarter Spectar Rgb Led Panel 5.0 Gebrauchsanleitung

6.

Commissioning

WARNING
Danger, due to incorrect use or handling.
■ Observe the safety instructions in the respective sections for all
activities.

6.1 Mounting the luminaire on a tripod

Always use the luminaire on a standard lamp tripod with a 5/8" spigot.
1. Set up the tripod properly (see the instructions for use).
2. Loosen the fixing screw of the bracket (4) on the LED luminaire and
place the bracket (4) on the spigot of the lamp stand.
3. Tighten the fixing screw of the bracket again (4) and make sure that it
grips the spigot at the narrowest point to prevent it from slipping off.
→ The circular hole in the bracket (4) allows the luminaire to be
mounted horizontally.
4. Check that the luminaire is held on the stand and that the stand is
secure.

6.2 Power supply via mains adapter

1. Switch off the luminaire so that you are not dazzled when you switch it
on. To do this, move the on/off switch (8) to the position [0].
2. Insert the plug of the power supply unit supplied into the socket (5) on
the back of the luminaire.
3. Connect the mains cable of the power supply unit to a protective
earthed socket of the local mains supply (AC 100-240 V, 50/60 Hz,
see technical data).
NOTE - Only operate the luminaire if the connection values match the
local power supply.
4. To switch on, set the on/off switch (8) to the position. [I].
EN
31