Instarter Spectar RGB LED Panel 5.0 Gebrauchsanleitung Seite 32

6.3 Power supply via rechargeable battery
WARNING
Risk of explosion or injury due to improperly used batteries.
Batteries can leak or explode if handled improperly.
■ Only use rechargeable batteries that are specified in these
instructions for use, see technical data.
■ Do not place batteries in a fire or expose them to direct heat.
■ Remove batteries if the luminaire is not to be used for a long time or
if the batteries are discharged.
■ If battery fluid comes into contact with skin or clothing,
rinse immediately with fresh water.
■ The batteries cannot be charged in the luminaire.
Use a suitable charger for this purpose.
■ Do not charge batteries unattended.
■ Disconnect the charger from the mains as soon as charging is
complete.
1. Switch off the luminaire. To do this, move the on/off switch (8) to the
position [0].
2. Remove the plug of the supplied power supply from the socket (5) on
the back of the luminaire.
3. Insert two sufficiently charged NP-F batteries from above into the two
battery sockets (11) of the luminaire.
→ A clear click indicates that they are securely in place.
4. To switch on, tilt the on/off switch (8) to the position [I].
Recommendations for the use of rechargeable batteries:
■ Replace the batteries at the latest when the light of the luminaire
starts to flicker.
■ Switch off the luminaire with the appropriate switch before removing
the batteries.
■ Avoid deep discharge of your batteries and recharge them as
soon as possible. This will ensure the long-lasting functionality and
performance of your batteries.
32