Adjusting The Screening Covers; Disassembly / Assembly Of The Diffuser - Instarter Spectar Rgb Led Panel 5.0 Gebrauchsanleitung

7.3 Adjusting the screening covers

The luminaire is delivered with pre-mounted screening covers (3). Flap open
the screening covers (3) one after the other and adjust them as desired.
Close the screening covers during transport or storage so that the lamps
are protected and nothing sticks out.

7.4 Disassembly / assembly of the diffuser

The luminaire is delivered with the diffuser (2) pre-mounted. The diffuser (2)
is held by the housing of the luminaire by retaining rails on the housing and
fixed by a bracket (1).
Remover diffuser
1. Fix the luminaire on the tripod by tightening the fixing screw of the
bracket (4).
2. Fix the two retaining screws (12), so that the luminaire can no longer turn
or tilt.
or
3. If you have not mounted the luminaire on a tripod, place it on a work
table with the illuminated surface facing upwards.
4. Open the upper screening cover (3).
5. Loosen the holder(1).
6. Pull the diffuser (2) upwards out of the retaining rails of the housing
7. Close the holder (1) again.
8. Store the diffuser in a safe place so that it is protected from scratches
and damage.
Insert diffuser
1. Fix the luminaire on the tripod by tightening the fixing screw of the
bracket (4).
2. Fix the two retaining screws (12), so that the luminaire can no longer turn
or tilt.
or
3. If you have not mounted the luminaire on a tripod, place it on a work
table with the illuminated surface facing upwards.
4. Open the upper screening cover (3).
5. Loosen the holder(1).
EN
35