English - ZAPTEC Go Bedienungsanleitung

English

Important information
Before using or maintaining this product, it is important to read the following safety instructions. Failure to
follow and apply all the instructions and procedures covered in this quick guide will invalidate the guarantee
and cause Zaptec Charger AS and direct partners to waive all liability and claims for compensation.
WARNING!
!
Read through the instructions carefully and
familiarize yourself with the equipment before
you start using it.
!
This equipment must only be installed, repaired,
and maintained by qualified personnel. Repairs
must be carried out by Zaptec or a pre-approved
workshop.
!
All applicable local, regional, and national laws
and regulations must be followed when installing,
repairing, and maintaining the product.
!
Do not install or use a product which is damaged
in any way. See the information in the chapter on
Support and Repairs.
!
Only use approved cabling for the installation.
Your charger is guaranteed by Zaptec Charger AS, Professor Olav Hanssens vei 7A, 4021 Stavanger, Norway
to be free from defects in materials and workmanship for a period of five (5) years from the date of its original
purchase. Read the full details at zaptec.com/guarantee or contact Zaptec support to request a copy. Your
statutory rights are not affected.
Get to know Zaptec Go
4
!
Do not insert foreign objects into the Type 2
socket.
!
Do not use high-pressure washers to clean the
charger station. Follow the instructions in the
chapter Storage and Maintenance.
! Avoid installing the charger in a location which is
exposed to direct sunlight.
!
Adapters are permissible – A conversion
adapter from the charger outlet must only be
used if specified and approved by the vehicle
manufacturer or charger producer
! Read the guarantee at zaptec.com/guarantee or
contact Zaptec support and request a copy.
Status light
Charge card authentication (RFID)
Type 2 socket