Operation - Dometic SKYSOL Montage- Und Bedienungsanleitung

Skysol Powered Roofblind
• Secure all cables to prevent any contact with moving parts.
• Only use power supply units and control elements recommended by the
manufacturer to prevent damage or faults during operation caused by incom-
patible electrical components.
• Control devices (e.g. switches) must be installed in visible locations.
➤ Connect the motor as shown in the wiring diagrams:
– Dometic radio controlled blind internal receiver (fig. g, page 12)
– Dometic radio controlled blind external receiver (fig. h, page 13)
– Manually switched blind (fig. i, page 13)
– Somfy radio controlled blind external receiver (fig. j, page 13)
– Somfy radio controlled blind internal receiver (fig. k, page 14)
Key to wiring diagrams
Pos.
1
2
3
4
5
bk
rd
gy
wh
I
NOTE
• Accessories are available using the separate order form.
• Observe the applicable documents for the controls and the operating ele-
ments.
8

Operation

A
NOTICE! Risk of damage while driving
Only for boats and yachts: If the blind is fitted beneath an open sunroof,
then the blind should be stowed when driving at more than 10 knots or with a
sea state of more than moderate, because this can damage the blind. Parts that
come loose may injure people in the vicinity.
EN
Description
Power supply
Head rail
Head rail motor options
External receiver
Customer supplied DPDTswitch (double pole, double throw), center off,
latching or momentary, 12/24 Vg, 3 A)
Black
Red
Gray
White
Operation
23