Safety Instructions; Installation Instructions; Installation Preparation - Create WINDLIGHT CURVE DC Bedienungsanleitung

When using any electrical appliance, basic safety precautions should always be observed.
• Read this entire manual carefully before beginning installation. Save this instructions.
• Use only original replacement parts.
• To reduce the risk of personal injury, attach the fan directly to the support structure of
the building according to these instructions, and use only the hardware supplied.
• To avoid possible electrical shock, before installing your fan, disconnect the power by
turning off the circuit breakers to the outlet box and associated wall switch location. If
you cannot lock the circuit breakers in the off position, securely fasten a prominent warn-
ing device, such as a tag, to the service panel.
• All wiring must be in accordance with national and local electrical codes and ANSI/NFPA
70. If you are unfamiliar with wiring, use a qualified electrician.
• To reduce the risk of personal injury, do not bend the blade attachment system when
installing, balancing, or cleaning the fan.
• Never insert foreign objects between rotating fan blades.
• To reduce the risk of fire, electrical shock, or motor damage, do not use a solid-state
speed control with this fan. Use only original speed controls.
• This appliance can be used by children aged from 8 years old and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children unless they are older than
8 and supervised. Close supervision is necessary when any appliance is used by or near
children.
NOTE: The important safety precautions and instructions appearing in the manual are not
meant to cover all possible conditions and situations that may occur. It must be understood
that common sense and caution are necessary factors in the installation and operation of
this fan.
Mark the correct position of the holes and fix the ceiling bracket using the screws with
metal anchor or screws and washers suitable for the type of ceiling chosen.
Check the correct installation of the bracket before hanging the fan. This plate must support
the full weight of the fan.
INSTAL L ATI ON PRE PAR ATI ON
• To prevent personal injury and damage,
ensure that the hanging location allows
the blades a clearance of 2.3 m from the
floor and 76 cm from any wall or obstruc-
tion.
• Be sure the outlet box is securely at-
tached to the building structure and can
support the full weight of the fan.

SAFETY INSTRUCTIONS

INSTALLATION INSTRUCTIONS

76 cm
from wall
or nearest
obstruction
2.3 m from blades to floor
E NG L I SH
7