Maxi-Cosi Pebble 360 Pro Kurzanleitung Seite 77

• Only use the newborn inlay of the Pebble 360 Pro until
your baby exceeds the 60 cm length limit. Afterwards
remove the newborn inlay from the Pebble 360 Pro.
WARNING:
• Never place the car seat on an elevated surface (such
as a table or chair).
• It is prohibited to adjust the seat position while
travelling.
Using Pebble 360 Pro
• When Pebble 360 Pro is installed on a stroller, always
make sure to use approved car seat adapters and to
secure Pebble 360 Pro correctly.
• The height of the headrest and the shoulder harness
can be set simultaneously into different positions. Pull
the headrest adjustment strap and meanwhile, pull
up or push down the headrest until it's in the correct
position.
Pebble 360 Pro in airplanes
• Installation of the Pebble 360 Pro on an aircraft seat
differs from the installation on a car seat.
• Installing the Pebble 360 Pro with a 2-point safety
belt is only allowed when used in an aircraft.
• In an aircraft, the Pebble 360 Pro may only be used on
forward-facing passenger seats.
• To install Pebble 360 Pro, place the infant carrier
rearward facing on the passenger seat.
Route the webbing of the-2point safety belt through
the belt guides. (1,2)
Lock the buckle of the 2-point safety belt. (3)
And tighten the 2-point safety belt by pulling on the
tightening strap. (4)
• The handle of the Pebble 360 Pro must be in upright
position.
• The belt buckle must not be positioned between
the belt hooks of this car seat. Otherwise a safe
attachment does not exist.
• To uninstall Pebble 360 Pro, open the buckle of the
2-point safety belt by lifting the lever of the buckle. (5)
And remove the webbing of the 2-point safety belt
from the guides. Make sure the Pebble 360 Pro does
not fall from passenger seat when opening the buckle.
• The Pebble 360 Pro must remain belted on the aircraft
seat, even when unoccupied.
• The Pebble 360 Pro is only for use on an aircraft seat
authorized by the airline.
• Do not install the Pebble 360 Pro in the area of airbag
deployment.
• Instructions of the cabin crew must be followed.
• The safety of your child for not complying with the
installation and instruction manual is not guaranteed.
CARE
• The cover, inlay, belt pads and sun canopy of the car
seat can be removed for washing. The front baleen of
the sun canopy needs to be removed before washing.
The harness webbing can be cleaned by using a wet
cloth.
• The plastic inserts of the shoulder pads do not need
to be removed before washing.
I
Maxi-Cosi Pebble 360 Pro 40-87cm / max. 13 kg
EN
I
77