Dometic Oceanair Skyscreen Powered Montage- Und Bedienungsanleitung Seite 18

Installation
The following notes must be observed when connecting the blinds:
• Ensure cables are not damaged during installation. Routings of cables
through walls or bulkheads must be protected and insulated by appropriate
bushing, grommets or cable conduits.
• Ensure that a 12 V or 24 V stabilized power supply line is available for the
drive at the point of installation. The power supply line is suitably arranged
and protected.
• The product must be connected to the correct power supply as specified on
the product label. The motor in the product is designed to cut out when a set
current is exceeded but the supply should be fused to protect the wiring to
the product.
• Secure all cables to prevent any contact with moving parts.
• Only use power supply units and control elements recommended by the
manufacturer to prevent damage or faults during operation caused by incom-
patible electrical components.
• Control devices (e.g. switches) must be installed in visible locations.
➤ Connect the motor as shown in the wiring diagrams:
– Dometic radio controlled blind internal receiver (fig. c, page 9)
– Dometic radio controlled blind external receiver (fig. d, page 10)
– Manually switched blind (fig. e, page 10)
– Somfy radio controlled blind external receiver (fig. f, page 10)
– Somfy radio controlled blind internal receiver (fig. g, page 11)
Key to wiring diagrams
Pos.
1
2
3
4
5
bk
rd
gy
wh
I
NOTE
• Accessories are available using the separate order form.
• Observe the applicable documents for the controls and the operating ele-
ments.
18
Description
Power supply
Head rail
Head rail motor options
External receiver
Customer supplied DPDTswitch (double pole, double throw), center off,
latching or momentary, 12 Vg/24 Vg, 3 A)
Black
Red
Gray
White
Skyscreen Powered
EN