Saw Blades; Cleaning And Maintenance; Change Carbon Brushes - Tectool Tsf 55 Originalbetriebsanleitung

2. Measure the desired distance and fix the parallel guide with the clamping
screws (22).

SAW BLADES

Compatible saw blades are necessary for the plunge saw to cut different
materials fast and clean.
Saw blades with few teeth (approx. 12 – 18 teeth) are suitable for longitudinal
cuts.
For cross cuts saw blades with at least 32 teeth are suitable; better are saw
blades with 48 teeth.
For cutting other materials such as aluminum special saw blades are
necessary.

CLEANING AND MAINTENANCE

Disconnect from mains power before carrying out any maintenance work on
the plunge saw!
All maintenance and repair work involving opening the motor casing must be
carried out by an authorized service center.
Always keep the plunge saw clean. Clean the plunge saw after every use with
a dry cloth or compressed air. Do not use any aggressive chemicals for
cleaning.

CHANGE CARBON BRUSHES

The saw is equipped with self-isolating
special brushes. They are
automatically isolated when worn, and
the tool stops. Check the carbon
brushes regularly. Replace the carbon
brushes with genuine spare parts if
they are worn to the wear limit (approx.
50% of the block). Always replace the
carbon brushes in pairs.
47