Before First Use; Intended Use; Plunge Saw Features - Tectool Tsf 55 Originalbetriebsanleitung

BEFORE FIRST USE

Remove the plunge saw and the accessories from the packaging. Check the
saw for transport damage and do not use the saw in case of damages. Keep
the packing materials away from children, risk of suffocation!

INTENDED USE

The plunge saw is intended to cut wood and similar materials, gypsum and
cement-bonded fiber materials and plastics.
The plunge saw is only to be used with a specifically designed guide rail.
Installation in a different or homemade guide rail or workbench can cause
serious accidents.

PLUNGE SAW FEATURES

The plunge saw comes with solid shaft electronics with following features:
Smooth start: The electronically controlled smooth start ensures a start of
the plunge saw without kickback.
Thermal fuse: The saw is equipped with a thermal fuse to protect against
overheating (motor burn-out). The protection circuit turns the motor off before
reaching a critical motor temperature. After cooling down for approx. 3 – 5
minutes the plunge saw is again ready to use and fully operational. In idle
speed the cooling period of the plunge saw is considerably reduced.
Current limitation: The current limitation prevents too high current draw
during extreme overload. This can cause reduced motor speed. After load
relief the motor starts up again immediately.
Constant speed: The preset motor speed is electronically kept. This allows
for continuous cutting speed even under load.
35