Haier HSW59F18DIMM Benutzerhandbuch Seite 32

CONTENTS
It is essential that the manufacturer's recommended installation, maintenance and filter
replacement requirements be carried out for the product to perform as advertised. See
Installation Manual for Warranty information.
Notice
While the testing was performed under standard laboratory conditions, actual
performance may vary. Replacement Cartridge: HRXWF For estimated costs of
replacement elements please visit our website at www.haierspares.eu.
WARNING!
► To reduce the risk associated with ingestion of contaminants:
► Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before and after the system. Systems certified for cyst
reduction may be used on disinfected water that may contain filterable cysts.
Notice
To reduce the risk of water leakage or flooding, and to ensure optimal filter
performance:
► Read and follow use instructions before installation and use of this system.
► Installation and use MUST comply with all state and local plumbing codes.
► Do not install if water pressure exceeds 120 psi (827 kPa). If your water pressure
exceeds 80 psi (552 kPa), you must install a pressure-limiting valve. Contact a
plumbing professional if you are uncertain how to check your water pressure.
► Do not install where water hammer conditions may occur. If water hammer conditions
exist you must install a water hammer arrester. Contact a plumbing professional if you
are uncertain how to check for this condition.
► Do not install on hot water supply lines. The maximum operating water temperature
of this filter system is 38°C.
► Protect filter from freezing. Drain filter when temperatures drop below 0.6°C.
► Change the disposable filter cartridge every six months or sooner if you observe a
noticeable reduction in water flow rate.
► Failure to replace the disposable filter cartridge at recommended intervals may lead to
reduced filter performance and cracks in the filter housing, causing water leakage or
flooding.
► This System has been tested according to NSF/ANSI 42, 53, 401 and P473 for the
reduction of the substances listed below. The concentration of the indicated
substances in water entering the system was reduced to a concentration less than or
equal to the permissible limit for water leaving the system, as specified in NSF/ANSI
42, 53, 401 and P473.
Care and cleaning
33