Technical Data - Konig & Meyer 19782 Nutzungsinformation

Technical data

Material
Load capacity
Dimensions and
adjustment range
Packaging
Weight
Mounting
To mount the desktop camera stand, proceed as follows:
1.) Unpack and check product for damage and completeness
Base, guide bush: PA-6, black
Clamping lever: POM, black
Floor protector: TPE
Knurled washer: Black anodised
Threaded bolt, clamping bolt, ball joint: Steel, galvanised
Feet, base tube, extension tube: Steel, powder-coated black
Joint: Zinc die-cast, powder-coated black
Threaded pin: Steel, blank
Clamping screw: PA and steel, zinc plated
1 kg
Base circle ø 260 mm
Height 280 to 488 mm
Ball joint 360° rotable and 90° tiltable
70 x 70 x 270 mm
0.53 kg
The desktop camera stand is completely assembled.
To set up the stand, unfold the three legs until they
click into place.