Specifications; Important Safety Instructions; Specific Safety Rules - Makita BFR540 Betriebsanleitung

ENGLISH
1. Red part
2. Button
3. Battery cartridge
4. Lever
5. Stopper base
6. Label on feeder box
7. Fenestella
8. Casing
9. Adjusting knob
10. Switch trigger

SPECIFICATIONS

No load speed (min
Overall length
Rated voltage
Standard battery cartridges
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to
screwdriver safety rules. If you use this power tool
unsafely or incorrectly, you can suffer serious
personal injury.
1. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
2. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high
locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
Explanation of general view
11. Reversing switch lever
12. Thumb screw
13. Plane bearing
14. Dust cover
15. Bit
16. Feeder box
17. Screw strip
18. Screw guide
19. Driving position
20. Reverse button
Model
Screw strip
-1
)
Net weight
BFR540
2.1 kg
D.C. 14.4 V
BL1430
SAVE THESE INSTRUCTIONS.
END004-1
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
ENE033-1
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
GEB017-1
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter,
stop operating immediately. It may result in a risk
of overheating, possible burns and even an
explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any
conductive material.
(2) Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.
(3) Do not expose battery cartridge to water or
rain. A battery short can cause a large current
flow, overheating, possible burns and even a
breakdown.
21. Hook
22. Wall
23. Limit mark
24. Front cover
25. Screws
26. Spring
27. Arm
28. Recessed part
29. Carbon brush cap
30. Hole
BFR550
4 x 25 - 55 mm
4,000
424 m
2.3 kg
D.C. 18 V
BFR750
4 x 45 - 75 mm
464 mm
2.3 kg
D.C. 18 V
BL1830
ENC007-2
5