Adjusting Salt Consumption - Kuppersberg GFM 4275 GW Bedienungsanleitung

TECHNICAL PASSPORT
Dishwasher
the control panel comes on. Depending
on how fully the salt dissolves, the
salt warning light may still be on even
though the salt container is filled.
 If there is no salt warning light
in the control panel (For some Models),
you can judge when to load the salt
into the softener by the cycles that the
dishwasher had run.
 If there are spills of the salt, a
soak or a rapid program should be run
to remove the excess salt.
ADJUSTING SALT
CONSUMPTION
 Please follow the steps below for
adjustment in salt consumption.
There are 6 levels of salt consumption in all. It is recommended to select the
level according to below table:
WATER HARDNESS
German
French
dH
fH
0–5 0–9
6–11 10–20
12–17 21–30
18–22 31–40
23–34 41–60
35–55 61–98
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
Every cycle with a regeneration operation consumes additional 0.5 litres of water, the energy
consumption increases by 0.01 kWh and the programme extents by 4 minutes.
46
softener
British
Mmol/l
Clarke
0–6 0–0,94
7–14 1,0–2,0
15–21 2,1–3,0
22–28 3,1–4,0
29–42 4,1–6,0
43–69 6,1–9,8
 Step 1: Enter the status of salt
adjustment
Close the door, within 60 seconds
after power on, press Rapid button and
hold for 5 seconds, the machine will
enter setting mode.
 Step 2: select a certain level of
salt consumption
Press the Rapid button to select
the proper set according to your local
environment, the sets will change in the
following sequence:
H1->H2->H3->H4->H5->H6.
 Step 3: Exit the status of salt
adjustment
Without any operation in five seconds,
the machine will exit from set mode, the
machine is into standby status.
Regeneration
Water occurs
every X
level program
sequence
No
H1
regeneration
H2 10
H3 5
H4 3
H5 2
H6 60
ENGLISH
Salt
consumption
(gram/cycle)
0
9
12
20
30
60