Water Softener; Adjusting Salt Consumption - Kuppersberg GFM 5572 W Bedienungsanleitung

TECHNICAL PASSPORT
Dishwasher

WATER SOFTENER

The water softener must be set manu-
ally, using the water hardness dial.
The water softener is designed to re-
move minerals and salts from the water,
which would have a detrimental or adverse
effect on the operation of the appliance.
The more minerals there are, the harder
your water is.
The softener should be adjusted ac-
cording to the hardness of the water in
your area. Your local Water Authority can
advise you on the hardness of the water in
your area.

Adjusting salt consumption

The dishwasher is designed to allow
for adjustment in the amount of salt con-
sumed based on the hardness of the wa-
ter used. This is intended to optimise and
customise the level of salt consumption.
Please follow the steps below for ad-
justment in salt consumption.
1. Close the door, switch on the ap-
pliance;
2. Within 60 seconds after the ap-
pliance was switched on, press the Pro-
gramme button for more than 5 seconds
to start the water softener setting mode ;
3. Press the Program button again
to select the proper setting according to
your local environment, the setting will
change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Without any operation in five
seconds or press the Power button to end
the setting mode, the setting is memo-
rized by the programme.
70
Please check the section 3
«Loading The Salt Into The Softener»
of PART I: Generic Version, If your
dishwasher lacks salt.
NOTE:
If your model does not have any
water softener, you may skip this section.
Water Softener
The hardness of the water varies
from place to place. If hard water is used
in the dishwasher, deposits will form on
the dishes and utensils.
The appliance is equipped with
a special softener that uses a salt
container specifically
eliminate lime and minerals from the
water.
ENGLISH
designed to