Turning On The Appliance - Kuppersberg GFM 4275 GW Bedienungsanleitung

ENGLISH
TURNING ON THE
APPLIANCE
Starting a wash cycle...
Draw out the basket(see the section
entitled «Loading the Dishwasher»).
Pour in the detergent (see the
section"Fill the detergent").
Insert the plug into the socket. The
power supply is 220-240VAC 50Hz, the
specification of the socket is 10A 250V AC.
Press the power button to turn on
the appliance,
Connect the inlet hose to the tap,
make sure that the water supply is
turned on to full pressure, or add water
the the tank manually.
Select a suitable program according
to the "Wash cycle table";
If a program is selected, the
corresponding light will be lit. Then
press the Start/Pause button, the
dishwasher begins to start.
NOTE
When you press the Start/Reset
button to pause during washing, the
dishwasher will beep every minute
unless you press the Start/Reset button
to start.
Saving Energy
1. Pre-rinsing of tableware items
leads to increased water and energy
consumption and is not recommended.
2. Washing tableware in a household
dishwasher usually consumes
energy and water in the use phase than
hand dishwashing when the household
dishwasher is used according to the
instructions.
Change the programme
Premise:
washing program, if the dishwasher
just worked for a short time. Otherwise,
the detergent may have already been
released, and the appliance may have
already drained the wash water in this
case, the cycle must be restarted.
 Press
pause the machine when the door is
closed,
 Press Program Button for more
than 3 seconds the machine will be in
stand-by state, then you can change the
program to the desired cycle setting
(see the section entitled «Starting a
wash program» ).
a) Display window shows «-:--» ---->
stand by;
b) Display window shows «H:MM»
and not blinking ---------> pause;
c) Display window shows «H:MM»
and blinking --------------> run;
d) Display window shows «END» ----
-------------> end.
NOTE
If you open the door during washing,
the machine will pause. When you
and press the Start/Pause Button, the
machine will keep on working after 10
seconds.
less
If your model has broken remember
function, the machine will go on to
finish the selected program after the
power cut.
TECHNICAL PASSPORT
Dishwasher
You can modify
Start/Pause Button
the
to
53