Automatic Defrost; Overload Protection - ecoQ CoolAir 12+ Benutzerhandbuch

D. Sleep Mode
The sleep mode can be activated when in cool mode.
W In COOL mode: After 1 hour the preset temperature is increased by 1 °C, after
another hour the preset temperature will again be increased by 1 °C.
5.4.3 Timer Setting (1 hour - 24 hours)
The timer has two ways of operation:
To turn off
(When power on)
To turn on
(When power off)
Cancel timer

5.4.4 Automatic Defrost

At low room temperatures, frost may buildup at the evaporator during operation. The
unit will automatically start defrosting and the POWER LED blinking. The defrost control
sequence is as follows:
A. When the unit operates in the cooling operation, drying operation, the ambient
temperature sensor senses the evaporator coil temperature is below -1 °C, after the
compressor will stop operating for 10 minutes or the coil temperature up to 7 °C, the
unit restart to cool operating mode.
B. When the unit operates in the drying operation, once the coil temperature sensor
senses the temperature of the evaporator is below 40 °C and the differential
temperature between coil temperature and room temperature is below 19 °C after the
compressor operation for 20 minutes, the unit start defrosting for 5 minutes and the
power indicator blinking.

5.4.5 Overload Protection

In the event of a power loss, to protect the compressor there is a 3-minute delay until the
compressor restarting.
5.4.3 Information on the ecofort App
The "ecofort" app is available for free on Android and iOS.
Scan the QR code to get directly to the download.
96 | Owner's Manual ecoQ CoolAir 12+
Press Timer key to
turn on the timer
function.
Press Timer key to
turn on the timer
function.
Press Up/Down repeatedly until the LED shows '00'.
Note: when press POWER will also exit the timer
setting.
Press Up/Down
repeatedly to set the
delay OFF time.
Press Up/Down
repeatedly to set the
delay ON time.