Error And System Messages; Reshipment - Vwr Rm 20 Bedienungsanleitung

H63.0.21.6C-02_VWR
ON
Auto Hold
0F
.
ON
Press again to store the changed settings, the device restarts (segment test).
NOTE: If there is no key pressed within the menu mode within 2 minutes, the configuration will be cancelled,
the entered settings are lost!

7 Error and System Messages

E. 1
Value exceeding measuring range, value too high
E. 7
System error - the device has detected a system error
(device defective or not within operating temperature)
Value below display range
The blinking bAt display indicates low battery voltage, device will continue to work for a short time.
The battery is consumed and has to be changed.
Measurements are no longer possible.

8 Reshipment

All devices returned to the manufacturer have to be free of any residual of measuring media and/or
other hazardous substances. Measuring residuals at housing or sensor may be a risk for persons or
environment.
DANGER
Use an adequate transport package for reshipment, especially for fully functional devices. Please make
sure that the device is protected in the package by enough packing materials.
Operating Manual RM 20
AtC activated:
factory setting: OF
AutoHold deactivated: pressing hold-key freezes measuring and
AutoHold activated:
instruments temperature is used for compensation.
releases it again.
hold-key starts new measuring, the display will be 'frozen'
as soon as a stable measuring value was detected.
page 8