EINHELL AQUINNA 18/30 F LED Originalbetriebsanleitung Seite 25

Faults
Insuffi cient The intake line has a leak or
pumping rate is damaged
Intake height too high.
The intake cage (incl. the
non-return valve) is soiled.
The coarse fi lter (incl. the
non-return valve) is soiled.
The hose on the discharge
side is kinked.
The cross-section on the
discharge side becomes
narrower.
The pump's delivery rate
depends on the delivery
head and on the connected
peripherals.
The battery is not correctly
inserted.
The battery is empty.
The motor The battery charge level
does not start is low.
The impeller is blocked.
The thermostat Overheating / overloading of
switches off the pump
the pump
The temperature of the
pumped medium or the en-
vironment is too high.
Dry-running of the pump.
Anl_AQUINNA_18_30_F_LED_SPK13.indb 25 Anl_AQUINNA_18_30_F_LED_SPK13.indb 25
GB
Possible cause
Check the following points for leaks:
- Intake line
- Water fi lling screw / water drain screw / ventilation
- Connection points of the intake line
Check the intake height.
Clean the intake cage (incl. the non-return valve).
Clean the coarse fi lter (incl. the non-return valve).
Remove any kinks in the hose.
Avoid narrow points.
Take account of the maximum delivery head, change
the hose diameter or hose length if necessary.
Remove the battery and insert it again.
Check the battery charge level and charge the batte-
ry if necessary.
Check the battery charge level and charge the batte-
ry if necessary.
Use a screwdriver to turn the motor shaft through the
fan hood (release the stuck mechanical seal).
Let the equipment cool down!
Take account of the permitted temperature of the
pumped medium.
Ensure that the pump is provided with adequate
cooling.
Eliminate the cause of the dry-running.
Note the points under "Pump fails to prime".
Prevent dry-running.
- 25 -
Remedy
screw / coarse fi lter cap
13.10.2022 14:52:17 13.10.2022 14:52:17