Automatic Closing Of The Osd After Inactivity; Changing The Position Of The Information Dispaly - G&D VisionXS-IP-C-DP-HR Installation Und Bedienung

Automatic closing of the OSD after inactivity

If desired, you can set the OSD to close automatically after a period of inactivity.
The period of inactivity can be defined by entering a value between
NOTE: To disable the function, enter the value
How to change the period of inactivity after which the OSD closes:
1. Press
Ctrl+Num
2. Press to open the
F10
3. Select the row
4. Enter the desired time range from
5. Press F2 to save your settings.

Changing the position of the information dispaly

In the default configuration, the information display is shown at the left upper corner
of the console monitor. However, you can adjust the position to your liking.
How to change the position of the information display:
1. Press
Ctrl+Num
2. Press F10 to open the
3. Select the row
The message on the right is shown at the current
position of the information display.
4. Use the arrow keys
menu to the desired position or press
5. Press F2 to save your settings or
(default) to open the OSD.
menu.
Personal Profile
Close OSD when inactive for [s]
5 to
(default) to open the OSD.
Personal Profile menu.
Set display position and press
or the mouse to move the
Esc to cancel the process.
5
0 .
and press Enter .
99 seconds and press
Enter .
+
Display position
F2: Save
Ctrl+D to reset the default position..
G&D VisionXS-IP-C-DP-HR · 92
Configuration
and 99 seconds.
Enter .