Establishing The Power Supply - G&D VisionXS-IP-C-DP-HR Installation Und Bedienung

Installation

Establishing the power supply

NOTE:
All device variants of the
power supply at the
The illustrations in this chapter show the DT variant of the device series. This
variant is additionally equipped with an internal power supply (
Transmission 1 Transmission 1 Transmission 2 Transmission 2 Service Service
Power/Main Power: Connect an external power supply to this interface.
.To provide a second, redundant power supply, insert an IEC cables here.
Red Power:
NOTE: PoE variants offer you an alternative power supply via Power-over-Ether-
net (PoE), class 6 (only via
For PoE supply, e. g. network switches or midspans (adapters in the network
lines) can be used. The counterpart must support PoE class 6.
11 · G&D VisionXS-IP-C-DP-HR
VisionXS-IP
interface (for DT variants:
Power
Network Network Pwr Pwr Main Power
Transmission 1
series can be operated with an external
Main Power
Red. Power
interface).
).
Red. Power ).