wavin Sentio Technisches Handbuch Seite 151

Optimization - boost percent
Optimization - ramping
Optimization - ramping time
Frost protection - Mode
Frost protection - Temp
High Temp Cut-Off - Mode
High Temp Cut-Off - Temp
Cooling Regulator - P value
Cooling Regulator - I value
Cooling Regulator - Hysteresis
Cooling inlet temp min
Cooling inlet temp max
ITC2 Same as ITC1
HCC CONTROLLERS
HCC1
Aggregated warning
Aggregated error
Error - inlet sensor failure
Error - High temp cut-off activated
State
Blocking source
Pump - Demand
Pump - State
Measured inlet temperature
Desired inlet temperature
Name
Heat curve - type
Heat curve - manual slope
Heat curve - parallel displacement
Heat curve - min inlet
Heat curve - max inlet
Heat curve - gain
High Temp Cut-Off - Mode
High Temp Cut-Off - Temp
HCC2 same as HCC1
HCC3 same as HCC1
H/C Source
H/C Source
Aggregated warning
Aggregated error
Error general failure
State
PERIPHERAL LIST
Peripheral 1
Aggregated warning
Aggregated error
Warning - low battery
Error - peripheral lost
Type
SN
Owner
Signal strength
Peripheral name
Peripheral 2
Peripheral 3
....
Peripheral 2-64
EXTERNAL DEVICES - Dehumidifier
Dehumidifier Device 1
Aggregated warning
Aggregated error
Warning - air filter lifetime expired
Warning - air filter solar year passed
Error - HCW supplier
Error - device fault
Type
Drying status
Drying blocking
Thermal integration status
Thermal integration blocking
Thermal Integ. demand condition
Air filter last change
Associated HCW supplier
Device name
Air filter lifetime
Air filter lifetime used
Drying allow in mode
Drying cooling water
www.wavin.de
0 DISABLED
1 ENABLED
07333
R/W Holding Register val_u1 Boost percent
R/W Holding Register 07334 val_u1 Rise desired temperature over ramping time.
0 DISABLED
1 ENABLED
R/W Holding Register 07335 val_u1 Ramping time
R/W Holding Register 07336 val_u1 Activate heating in assigned loops whe inlet temperature drops
bellow "Frost protection - Temp"
R/W Holding Register 07337 val_d2_fp100 Frost protection limit
R/W Holding Register 07338 val_u1 Heating is blocked, when inlet temperature exceeds the limit.
Alarm is raised, pump is switched off (ignoring all pump delay).
0 DISABLED
1 ENABLED
R/W Holding Register 07339 val_d2_fp100 Limit temperature for High Temp Cut-Off
R/W Holding Register 07340 val_d2_fp10 Proportional gain of temperature regulator in cooling mode
R/W Holding Register 07341 val_u2 Integrating time of temperature regulator in cooling mode
R/W Holding Register 07342 val_d2_fp100 Hysteresis in cooling mode
07343
R/W Holding Register val_d2_fp100 Lowest possible temperature in cooling mode
R/W Holding Register 07344 val_d2_fp100 Highest possible temperature in cooling mode
074xx
077xx
R Discrete Inputs 07701 A problem is pending in ITC
07702
R Discrete Inputs A critical problem is pending in ITC
Discrete Inputs 07703
R Discrete Inputs 07704 Safety mechanism "high temp cut-off" is activated
R Input Register 07701 val_d1 1 IDLE
2 HEATING
3 COOLING
4 BLOCKED_HEATING
5 BLOCKED_COOLING
R Input Register 07702 val_u1 Same as Heating/Cooling blocking source
R Input Register 07703 val_u1 1 IDLE
2 ON
R Input Register 07704 val_u1 1 IDLE
2 ON
R Input Register 07705 val_d2_fp100 Measured temperature of the inlet heating/cooling water.
07706
R Input Register val_d2_fp100 Desired temperature of the inlet heating/cooling water.
The value which the ITC regulator wants to meet.
R/W Holding Register 07701-07716 val_utf8 String description (32 Bytes, UTF8, NULL terminated)
R/W Holding Register 07717 val_u1 0 MANUAL
1 CALCULATED
2 UNDERFLOOR
3 RADIATORS
R/W Holding Register 07718 val_d2_fp10 Curve slope.Used only in MANUAL
R/W Holding Register 07719 val_d2_fp100 Shifts calculated temperature up/down
R/W Holding Register 07720 val_d2_fp100 Lowest possible temperature
R/W Holding Register 07721 val_d2_fp100 Highest possible temperature
R/W Holding Register 07722 val_d2_fp10 Static gain of desired temperature calculation
R/W Holding Register 07723 val_u1 Heating is blocked, when inlet temperature exceeds the limit.
Alarm is raised, pump is switched off (ignoring all pump delay).
0 DISABLED
1 ENABLED
R/W Holding Register 07724 val_d2_fp100 Limit temperature for High Temp Cut-Off
078xx
079xx
R Discrete Inputs 08101 A problem is pending in H/C Source
08102
R Discrete Inputs A critical problem is pending in H/C Source
R Discrete Inputs 08103 General failure
R Input Register 08101 val_d1 1 IDLE
2 HEATING
3 COOLING
4 BLOCKED_HEATING
5 BLOCKED_COOLING
512xx NOTE: Dynamic list of peripherals. Position of the peripherals is not fixed. It can change
when a peripheral is learned or unlearned.
51201
R Discrete Inputs A problem is pending in Room
R Discrete Inputs 51202 A critical problem is pending in Room
R Discrete Inputs 51203 Battery is low in the peripheral.
R Discrete Inputs 51204 Peripheral is not responding.
R Input Register 51201 val_u2 Peripheral type - Sensor, Termostat, .. (product number)
R Input Register 51202-51203 val_u4 Serial number
R Input Register 51204 val_u2 000 - Location
001 - Room 1
...
016 - Room 16
NOTE: Object address in this modbus table is used as owner_id
R Input Register 51205 val_d1 Peripheral Signal strength
R/W Holding register 51201 - 51216 val_utf8 String description (32 Bytes, UTF8, NULL terminated)
513xx
514xx
575xx
650xx
R Discrete Inputs 65001 A problem is pending in device
R Discrete Inputs 65002 A critical problem is pending in device
R Discrete Inputs 65003 Air filter lifetime expired
R Discrete Inputs 65004 Air filter solar year passed from last air filter change
R Discrete Inputs 65005 Heating/Cooling water supplier is not set
R Discrete Inputs 65006 Device fault - general signal from device
R Input Register 65001 val_u1 Device type
0 GENERIC
1 P300_S300
2 PC300_SC300
R Input Register 65003 val_u1 0 NONE (function not available)
1 IDLE
2 DRYING
3 BLOCKED_DRYING
R Input Register 65004 val_u1 Please check top of the document - GENERAL BLOCKING SOURCES
R Input Register 65005 val_u1 0 NONE (function not available)
1 IDLE
2 HEATING
3 COOLING
4 BLOCKED_HEATING
5 BLOCKED_COOLING
R Input Register 65006 val_u1 Please check top of the document - GENERAL BLOCKING SOURCES
R Holding Register 65007 val_u1 100 - IN ANY ROOM
101 - IN ALL ROOMS
1-32 - PARTICULAR ROOM (Address of modbus object)
65010-11
R Input Register val_u4 Timestamp, updates when register "Air filter lifetime used" is set to zero
R Input Register 65012 val_u1 0 .. NONE
73 .. ITC1 (Address of modbus object)
74 .. ITC2 (Address of modbus object)
77 .. HCC1 (Address of modbus object)
78 .. HCC2 (Address of modbus object)
79 .. HCC3 (Address of modbus object)
81 .. H/C Source (Address of modbus object)
R/W Holding register 65001-65016 val_utf8 String description (32 Bytes, UTF8, NULL terminated)
R/W Holding Register 65017-65018 val_u4 Air filter lifetime (minutes)
R/W Holding Register 65019-65020 val_u4 Write 0 to reset timer
R/W Holding Register 65021 val_u1 0 - IN COOLING MODE
1 - IN HEATING MODE
2 - IN BOTH
R/W Holding Register 65022 val_d2_fp100 Desired cooling water temperature
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- - YES
- - YES
- - YES
- - YES
- - YES
- YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES CHANGED YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
YES YES YES
- - YES
- - YES
- - YES
- - YES
- - YES
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- YES YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
- - YES
Sentio Technisches Handbuch
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
151