Making Cuts At An Angle Across The Surface Of The Workpiece; Transport And Storage - Hilti SCW 22-A Original Bedienungsanleitung

All manuals and user guides at all-guides.com

5.9.3 Making cuts at an angle across the surface of the workpiece

1. Position the guide rail with the zero mark at the edge of the workpiece and then pivot the rail until the
desired angle shown on the angle scale is opposite the zero mark. The cutting angle indicated is the
angle of deviation from a straight, right-angled cut.
2. Use the two screw clamps to secure the guide rail.
5.10 Using the saw without a dust and chip removal system
1. Check that the sawdust is ejected without obstruction.
2. If required, the hose connector can be removed from the blade guard after releasing the hex. socket
screw using the wrench supplied (located on the product).
5.11 Procedure if the chip / dust channel is blocked
1. Pull the battery out of the product to the rear.
2. Clean the chip / dust channel.
Note
Remove the saw blade if necessary.
3. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may
affect operation of the product.
6 Care, maintenance, transport and storage
6.1 Care of the product
WARNING
Electrical hazards. Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Keep the product, especially its grip surfaces, clean and free from oil and grease. Do not use
cleaning agents containing silicone.
▶ Never operate the product when the air vents are blocked. Clean the air vents carefully using a dry brush.
Do not allow foreign objects to enter the interior of the product.
▶ Clean the outside of the product at regular intervals with a slightly damp cloth. Do not use a spray, steam
pressure cleaning equipment or running water for cleaning.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables.
Spare parts, consumables and accessories approved by Hilti for use with the product can be
found at your local Hilti Center or online at: www.hilti.com
6.2 Care of the lithium­ion batteries
▶ Keep the battery clean and free from oil and grease.
▶ Clean the outer surfaces of the tool with a slightly damp cloth at regular intervals. Do not use cleaning
agents containing silicone.
▶ To achieve maximum battery lifetime, stop drawing power from the battery as soon as a significant drop
in the performance of the power tool is noticed.
▶ Charge the batteries using the Hilti chargers approved for use with Li-ion batteries.

6.3 Transport and storage

WARNING
Risk of fire! Risk of short circuiting
▶ Never store or transport Li­ion batteries in loose, bulk form.
▶ Remove the battery from the product before transport or storage.
24