Clean Air Optima CA-603 Bedienungsanleitung Seite 7

Press the On/Off Button to activate the humidifier. The machine is now operating in manual
mode. It will release cool mist on a constant basis with the mist intensity level automatically set to
medium. The nozzele jet at the top of the machine can be rotated to blow mist in 360 degrees
directions. You may also lift the nozzele from the water tank, adjust the positions and reinsert back
into the top of the water tank. The output nozzele jet should not be set to spray directly onto
people, electrical devices or any obstructions. It is best to direct the nozzele jet into the open air.
The Min/Max Button changes the mist level (low, medium, high). This change is displayed on the
LCD screen by the numbers 1, 2 , 3. If the machine is in automatic mode, it will automatically
adjust the mist intensity.
Pressing the Humidity Button activates automatic mode. You can select the desired humidity
level by pressing this button repeatedly until the required humidity level is displayed (from 45% to
75% in increments of 5%). Once you select your desired humidity level, simply stop pressing the
button and your humidity level will be set. Wait another 5 seconds and the numeric value on the
LCD display will switch to the current humidity level as measured by the built-in Hygrostat. When
the humidity level in the room reaches the set humidity level, the machine will go into automatic
sleep state and stop producing mist. When the room's actual humidity level drops below your set
humidity level then the machine will start producing mist again.
You can deactivate automatic mode very easily by pressing the humidity button until you reach
75% RH. Press the button one more time and you will now be in manual mode.
Pressing the Ion Button will activate the negative ion generator and start sending healthy
negative ions into the air. It will be represented by the tree icon displayed on the LCD screen.
The Timer Button sets the timer. The timer function determines how many hours the humidifier
will operate. You can set the timer simply by pressing it once for each two hours that you would
like to run the unit. You can set the timer from 1 hour to 12 hours. As time passes, the time value
decreases until it goes to 00:00 and the machine shuts off.
If the humidifier should run out of water, you will hear a beeping sound before the machine will
automatically shut off. The LCD screen will display the Empty Water Tank icon.
7