Clean Air Optima CA-603 Bedienungsanleitung Seite 6

The Clean Air Optima CA-603 is equipped with a Permanent Reusable White Dust & Anti-
Microbial Filter. It consists of an inner cylinder, an outer cover and a number of small plastic and
ceramic balls. The plastic balls are embedded with nano-silver, an anti-microbial agent designed to
purify the water and destroy microbes such as bacteria and mould. The ceramic balls function to
soften the water by adhering to minerals that cause white dust. They also serve to remove any
unpleasant odour from the water. The filter requires cleaning about once a month or 1,000 hours of
use. See the Maintenance section of more information.
OPERATING INSTRUCTIONS
Operating Instructions
Before getting started, please remove the Clean Air Optima CA-603 from its box and allow it to
become accustomed to the room temperature for at least 30 minutes especially if the machine is
cold from the outside air. The CA-603 is designed to operate at temperatures between 5 -40 ºC
and relative humidity of less than 80%.
To get started, first remove the nozzele than grasp the water tank by the handle at the top and lift
from the base. Next, flip the tank over and unscrew and remove the water tank lid and filter.
Then place the water tank under the faucet for filling. Fill the tank with tap water (or other clean
water source with water temperature under 40ºC), re-insert the lid and filter. Flip the water tank
once again until it is on the right side up. Ensure that the basin is clean and then carefully place
the water tank back on the lower body.
Wait a few seconds until the water tank lid starts to release water into the basin. You will hear a
bubbling sound as the air enters the water tank. Plug the power cord into the electrical outlet
(NEVER SWITCH ON THE HUMIDIFIER WITHOUT WATER IN THE BASIN). If the humidifier is
switched off, the power icon should now be red and the values for temperature and humidity will
now be displayed.
6