be cool BC30LEF2301 Bedienungsanleitung Seite 31

Mode - Key
Press this button to switch between the different modes. The
respective lamp lights up.
On / Off – Key
Press this button to switch the dehumidifier on or off.
Operating modes
Timer
•
Press the timer button once to activate the timer mode.
•
The display lights up, flashes and shows "00".
•
Press the timer button repeatedly and select between 1 - 24 hours. After
selecting the timer time, wait 5 seconds, the appliance will automatically
confirm the time.
•
If the unit is in standby, use steps 1 - 3 to set an automatic switch-on time
Timer off: As soon as the desired time has elapsed, the unit switches off.
Timer on: As soon as the desired time is reached, the unit switches on
automatically.
Auto Mode
In AUTO dehumidification, the compressor starts automatically as soon as the
room humidity is 5% higher than the set humidity, the fan runs at the set
speed.
If the humidity is 5% below the set humidity, the compressor stops, but the fan
continues to run at the set speed. If the room humidity is between + 5% and -
5% of the set humidity, the unit continues to run until the room humidity is 5%
below the currently set target value.
The default value set at the factory is 50% and can be selected in five steps
between 30% and 80% by repeatedly pressing the "Humidity setting" button.
Continuous Mode
In this mode, the unit runs continuously until it is either switched off, the timer
switches the unit off or the water tank is full, unless the drain hose is used. In
this mode, no target room humidity can be selected.
Seite 30 von 38