BOMANN VS 7345 Bedienungsanleitung, Garantie Seite 23

• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
- at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Assembling the door handle
Remove the screw hole covers from the outside of
the door and screw the handle into the holes under-
neath using the screws provided. Put on the screw
covers included in the scope of delivery.
Leveling the appliance
To ensure sufficient leveling and air circulation in the
lower rear area of the appliance, the feet may need
to be adjusted.
Slight unevenness of the floor can
be compensated via the front feet
(F).
For the doors to close automatical-
ly, tilt the top back by 10∼15 mm.
If the appliance is not balanced,
the feet must be readjusted.
Assembling the rubber supporting pad
CAUTION:
Under extreme circumstances, there is a risk that the
appliance may tilt forward.
NOTE:
Installation of the rubber supporting pad is ONLY
necessary if the interior is empty and the refrigerator
door is loaded with 15 kg or more.
Tilt the appliance slightly backwards and lock it in this
position. Fasten the enclosed rubber supporting pad
with the screw in the provided hole on the underside
of the door.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
23