SCOPREGA GM 5 Anleitung Seite 5

M A N U A L O F
2. FOREWORD
Dear customer,
congratulations on choosing Scoprega.
We design and manufacture products of the highest quality to meet the needs
of our customers. Scoprega offers the highest quality in service as well. Our
specialised departments provide support and instructions when needed, as well
as comprehensive technical service.
We thank you for your trust.
WARNING
Read these instructions before using the inflator. Failure to follow all the instructions listed
below may result in damage to the product and/or cause serious injury to persons.
3. GENERAL SAFETY RULES
1. ALWAYS TAKE INTO ACCOUNT THE WORKING ENVIRONMENT. Do not expose the pump to rain.
Do not use in the presence of flammable liquids or gases.
2. Do not use the pump with the inlet in contact with dust or water.
3. BE CAREFUL. Care must always be taken. Use common sense.
4. DO NOT INHALE! The compressed air coming from the pump is not clean
Never inhale air from the pump or from a breathing device connected to the pump.
5. Never handle the pump using the hose.
4. INTRODUCTION
The GM 5 is a reliable and efficient hand pump (less effort to inflate). It is manufactured with
recycled and recyclable plastic material and the inner tube is in CIRCAL® aluminum, composed
of 75% recycled aluminum.
"No hose kinking" during inflation thanks to the air outlet placed on the pump body itself
The feet at the base are foldable and the handle can be disassembled, saving space in the
package.
The GM5 comes with adapters for various types of inflation valves and with a high quality 1.25m
hose (LDPE + EVA).
6. FEATURES
ITEM CAPACITY
CODE
GM 5
GM1S0000 2 x 2000 cc ABS + Alluminium
8
MAX.
MATERIAL PRESSURE
FUNCTIONS
(mbar)
1.0 bar INFLATION/
(14.5 psi) DEFLATION
I N S T R U C T I O N S
6. INSTRUCTIONS FOR USE
TO INFLATE
• The pump is equipped with standard nozzles available in the package.
• Connect the hose on the front side of the pump (Fig. 1 page 3) and make sure that
"Mode" lever on the rear side of the pump (Fig. 3 page 3) is in the "DOUBLE ACTION"
position as indicated on the pump.
• Connect the pump to the inflatable product.
• Screw the knobs on the handle and open the feet at the base for more stability.
• Start pumping. When the strain increases, turn the "Mode" lever (SINGLE ACTION as
indicated on the pump) on the rear side of the inflation port 180° counter-clockwise (Fig.
3 page 3).
• Continue pumping until reaching the desired pressure.
TO DEFLATE
• Connect the hose to the handle port (Fig. 2 page 3) and make sure that "Mode" lever
on the rear side of the pump (Fig. 3 page 3) is in the "DOUBLE ACTION" position as
indicated on the pump.
• Connect the pump to the inflatable product.
• Continue pumping until the inflatable product is empty.
7. TROUBLESHOOTING
POSSIBLE CAUSE
PROBLEM
Hose improperly
The pump does
connected.
not inflate
Internal seals or valves
damaged
The recommended accessories when using the inflator are the original SCOPREGA ones.
The use of any accessory not recommended for this inflator can be dangerous.
POSSIBLE SOLUTION
Connect the hose to the correct port.
Contact a SCOPREGA service
centre.
9