Flight Guide; Flight Preparation And Turning The Drone On/Off - SYMA X220W Bedienungsanleitung

4.0 Flight guide

4.1 Flight preparation and turning the drone on/off
Pairing the remote control with the drone
Remote control
indicator lights
flashes rapidly
Note:
!
* When you switch on the remote control, the indicator light will flash rapidly for
approximately 20 seconds to indicate that the remote control is waiting for a signal. The
indicator will then flash slowly to indicate that the pairing mode has been disabled.
Calibrating the compass
1
Press to calibrating
the compass
Note:
!
* Do not calibrate the compass near strong electromagnetic fields or large pieces of metal, car
parks or buildings with underground steel reinforcements.
* When holding the drone horizontally, the angle of inclination must not exceed 30 degrees.
Switch on the remote control Indicator lights
flashes rapidly to slowly
2
Hold the drone horizontally
and rotate 360 degrees
a few times. Indicator lights
flashes from slowly to rapidly
Indicator lights stays constant
when pairing is complete.
Hold the drone vertically
and rotate 360 degrees a few
times. Indicator lights flashes
from rapidly to constant
3
8