Preparing The Remote Control; Remote Control Battery Installation - SYMA X220W Bedienungsanleitung

* Always check the battery's condition before charging or using it. Replace the battery if it has
been dropped, or in case of odor, overheating, discoloration, deformation, or leakage.
* Use only the supplied charging cable.
* The battery temperature must never exceed 60℃(140°F) otherwise the battery could be
damaged or ignite.
* Never charge on a flammable surface, near flammable products, or inside a vehicle
( preferably place the battery in a non-flammable and non-conductive container)

3.4 Preparing the remote control

Remote control battery installation

Battery Compartment
Note:
!
* When installing the batteries, ensure that you match the + and ‒ ends of the battery with the +
and ‒ signs on the controller.
* During the battery installation, it must be ensured that the polarities of the batteries are
matched with that of the battery box. No battery shall be installed with the opposite polarity.
* Please do not use new and old batteries together.
* Please do not use different types of batteries together.
* Do not use rechargeable batteries.
7
Open the remote control
Close the remote control
Battery Cover
4×1.5V "AAA" Battery
(Not included)