Velleman CAMIP5N1 Bedienungsanleitung Seite 12

11.12 Mail Service Settings
Define mail service settings
Note
The settings on this page will only take effect if the option Send Mail on Alarm is selected in the Alarm
Service Settings (see below).
1. Fill in a senders e-mail address in the Sender field.
This is the mailbox from which the mails will be sent.
2. Fill in up to 4 receivers mail addresses.
When an alarm condition occurs, mail is sent out to these addresses.
3. Fill out all SMTP data related to the sender's mailbox.
4. If authentication for the mailbox is required, select the checkbox and enter user name and password in
the appropriate fields.
5. If the Report Internet IP by Mail box is selected, a mail is sent whenever a camera comes online (for
example after reboot) or a change in IP address occurs.
Make sure the port is correctly mapped to the router.
 Click Submit to save the data before performing a 'mail test'.
Possible error messages
Following error messages may appear:
Error message
Cannot connect to the server
Network error. Please try later.
Server error.
Incorrect user or password.
The sender is denied by the server.
The receiver is denied by the server.
The message is denied by the server.
The server does not support the authentication
mode used by the device.
V. 05 – 04/06/2015
CAMIP5N1
Possible solution
Check network cables and settings.
Check network cables and settings.
Check the server.
Make sure to enter the right user name and
password.
Check whether the user needs authentication.
Could be due to anti-spam settings of the server.
Could be due to anti-spam settings of the server.
Try without authentication or use a different server
(sender address).
12 ©Velleman nv