NORAUTO NS-218 BT Bedienungs- Und Sicherheitshinweise Seite 90

Ì Be sure to ground this unit to the car's chassis again after
EN
installation.
Ì If the power is not turned ON, the speaker wire may have
a short-circuit or touched the chassis of the vehicle and the
protection function may have been activated. Therefore, the
speaker wire should be checked.
Caution
Ì If your car's ignition does not have an ACC position, connect the
ignition wires to a power source that can be turned on and off
with the ignition key. If you connect the ignition wire to a power
source with a constant voltage supply, as with battery wires, the
battery may die.
Ì Install this unit in the console of your vehicle. Make sure the
faceplate will not hit the lid of the console (if any) when closing
and opening.
Ì After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
Ì Mount the unit so that the mounting angle is 30° or less.
Ì If the fuse blows, first make sure the wires are not touching to
cause a short circuit, then replace the old fuse with one that has
the same rating.
Ì Connect the speaker wires correctly to the terminals to which
they correspond. The unit may be damaged or fail to work if you
share the
Ì When only two speakers are being connected to the system,
connect the connectors either to both the front output terminals
or to both the rear output terminals (do not mix front and rear).
Ì Mounting and wiring this product requires skills and experience.
For safety's sake, leave this work to professionals.
If you experience problems during installation, consult your
NORAUTO dealer.
90
wires or ground them to any metal part in the car.