Temperature Setting - Mitsubishi Electric Mr. SLIM PSA-M KA-Serie Bedienungshandbuch

3. Operation

3.3. Temperature setting

<Cool, Dry, Heat, and Auto>
Fri
28.5
Room
Cool Set temp. Auto
Mode Temp. Fan
F1 F2 F3 F4
Press the [F2] button to decrease the preset temperature, and press the
[F3] button to increase.
• Refer to the table on 3-1 for the settable temperature range for different
operation modes.
• Preset temperature range cannot be set for Fan/Ventilation operation.
• Preset temperature will be displayed either in Centigrade in 0.5- or
1-degree increments, or in Fahrenheit, depending on the indoor unit
model and the display mode setting on the remote controller.
en
• Refer to "Function settings" in the installation manual for the 14°C cool-
ing setting.
3.4. Fan speed setting
28.5
Room
Cool Set temp. Auto
Mode Temp. Fan
F1 F2 F3
Press the [F4] button to go through the fan speeds in the following order.
• The available fan speeds depend on the models of connected indoor
units.
Notes:
The number of available fan speeds depends on the type of unit
●
connected.
In the following cases, the actual fan speed generated by the unit
●
will differ from the speed shown the remote controller display.
1. While the display is in "Standby" or "Defrost" states.
2. When the temperature of the heat exchanger is low in the heat-
ing mode.
(e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the tem-
perature setting.
4. In COOL mode, when room temperature is lower than the tem-
perature setting.
5. When the unit is in DRY mode.
6
28
Room
Cool Set temp.
Mode Temp.
Example display
(Centigrade in 1-degree increments)
Fri
F4
Auto
3.5. Airflow direction setting
<[Manual] To Change the Airflow's Up/Down Direction>
Fri
PSA-M•KA Series
Hold both ends of the vanes and move them to the desired position. Nor-
mally, set the vanes to the horizontal or upward airflow direction for cool-
Auto
ing or drying mode, and set the vanes to the downward airflow direction
for heating mode.
Fan
* When the airflow direction is adjusted, the uppermost
and lowermost vanes do not move together with the
other vanes.
<To Change the Right/Left Air Direction>
Main Main menu
Operation
F1 F2
Operation
Vane•Louver•Vent. (Lossnay)
High power
Comfort
Main menu:
Cursor
F1 F2
F1 F2
Caution:
To prevent falls, maintain a stable footing when operating the unit.
Select "Operation" from the Main
menu, and press the [SELECT]
button.
F3 F4
Select "Vane•Louver•Vent. (Loss-
nay)" from the Operation menu, and
press the [SELECT] button.
F3 F4
Press the [F3] button to turn the lou-
Fri
ver swing ON and OFF.
On Off
Off
Off
Louver Vent.
F3 F4
On
On