Electrolux DMGL8372UO Benutzerinformation Seite 24

24 www.electrolux.com
Problem
An acoustic signal
sounds and the hob de‐
activates.
An acoustic signal
sounds when the hob is
deactivated.
The hob deactivates.
Residual heat indicator
does not come on.
The control panel be‐
comes hot to the touch.
There is no sound when
you touch the panel sen‐
sor fields.
The indicator above the
symbol
The control bar blinks.
The control bar for hood
blinks and the hood does
not start or turns off.
Possible cause
You put something on one
or more sensor fields.
You put something on the
sensor field
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
The cookware is too large
or you put it too close to
the control panel.
The sounds are deactiva‐
ted.
Child Safety Device or
Lock operates.
comes on.
There is no cookware on
the zone or the zone is not
fully covered.
The cookware is unsuita‐
ble.
The diameter of the bottom
of the cookware is too
small for the zone.
The fan may turn off by it‐
self in certain conditions,
e.g. when the room is not
properly ventilated.
Remedy
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Put large cookware on the
rear zones, if possible.
Activate the sounds. Refer to
"Daily use".
Refer to "Daily use".
Put cookware on the zone so
that it fully covers the cook‐
ing zone.
Use cookware suitable for in‐
duction hobs. Refer to "Hints
and tips".
Use cookware with correct
dimensions. Refer to "Tech‐
nical data".
Open the window (you may
need to install the window
switch, refer to "Hints and
Tips for the Hood"). Press
any symbol. The hood oper‐
ates again.