Description Of Accessories; Orientation; Ec Declaration Of Conformity - Vortice VORTICENT C 30/2 M Betriebsanleitung

not therefore require an external thermomagnetic
cutout. They still require a multipolar switch with a
contact gap of at least 3mm, however.
• Fit a spring washer or other such material between
the wall and the appliance's flange if the wall surface
is uneven.
• If the appliance is installed outdoors, ensure that
adequate weather protection is provided.
• Operating temperature from -25°C a +40°C.

DESCRIPTION OF ACCESSORIES

Protective grille, delivery side
Fits over the appliance's delivery outlet to prevent
accidental contact with moving parts if the appliance
is installed at an accessible height.
Protective grille, intake side
Fits over the appliance's suction inlet to prevent
accidental contact with moving parts if the appliance
is installed at an accessible height.
Flanged suction connector
Facilitates coupling to a duct with an intermediate
seal or anti-vibration joint.

ORIENTATION

The orientation of a radial fan's delivery outlet (fig. 5)
is represented by a direction of rotation symbol (LG
for anti-clockwise and RD for clockwise, looking from
the side opposite the suction inlet) and the angle (in
degrees) of the delivery outlet to the reference axis
(a straight line perpendicular to the base plane,
passing through the axis of rotation), measured in
the direction of rotation.

EC DECLARATION OF CONFORMITY

VORTICE ELETTROSOCIALI S.p.A
Strada Cerca, 2 - frazione di Zoate
20067 TRIBIANO (MI) - ITALY
declares, under his own responsibility,
that the products in the range:
VORTICENT
conform to European Directives
• CEE 98/37
• CEE 89/336
• The appliance cannot be used to control water
heaters, room heaters, etc.; neither must it exhaust
into the hot air flues of such appliances.
• Do not cover the appliance's intake and outlet
grilles.
N.B.
Do not submerge the electric motor in water or
any other liquid.
Motor support
Supports the appliance when it cannot be supported
by its delivery outlet.
Voltage regulator
3 position speed controllers. IRM 40 single phase
voltage regulator for models C 20/2 M; C 25/2 M. IRT
35 three phase voltage regulator for models C 20/2
T; C 25/2 T.
Electronic speed controllers
Speed controllers for single phase fans. IREM 5
speed controller for one or more fans, up to a
maximum of 5 A, for models C 20/2 M; C 25/2 M.
All models except C 46 are normally supplied with
an anti-clockwise LG 90° orientation. Model C 46 is
normally supplied with an anti-clockwise LG 270°
orientation.
Follow the steps illustrated in fig. 4 to change the
orientation of the motor.
according to the following standards:
EN 292-1 (1991)
EN 292-2 (1991) + A1 (1995)
EN 60204-1 (1997)
EN 55014-1 (2000) + A1 (2001) + A2 (2002)
EN 55014-2 (1997) + A1 (2001)
EN 61000-3-2 (2000)
EN 61000-3-3 (1995) + A1 (2001)
EN
11