Common faults
The machine cannot be turned on
The machine stopped suddenly
during operation, and alarm
sounded.
The auger has been scratched
Very little juice is extracted
There is a lot of water in the pulp
The screen wiper basket does not
rotate during operation
The juicing bowl shakes slightly
when the machine is turned on
The safety lid cannot be opened
after juicing
12
Handling method
Check if the plug has been plugged in properly.
Check if the juicing has been fitted properly.
Is the machine clogged from excessive feeding (too
many pieces or pieces too large)? Turn the switch
knob to the "Reverse" position and allow the machine
to run in the reverse mode for 5 seconds.
Has the machine entered its safety mode after
working continuously for more than 20 minutes?
Allow the machine to rest for 30 minutes, then try again.
If you are unable to resolve the problem after trying
the above, get in touch with our customer service.
The gap between the auger and screen is very small;
avoid running an empty machine as far as possible.
Water content varies between different fruits and
vegetables.
Fruits and vegetables also produce less juice when
they lose their freshness.
When juicing hard fruits and vegetables, check that
the adjustment lever is in the "Open" position
When juicing soft fruits and vegetables, check that
the adjustment lever is in the "Closed" position.
Check if the gear (L) at the base of the juicing bowl has
not deteriorated, if so contact your customer service.
Slight shaking of the juicing bowl during operation
is normal.
There could be too much residual pulp in the
machine, or the fruits being juiced may have hard
pits, etc. Turn the lever (F) in open position, Turn the
switch knob to the "Reverse" position and allow the
machine to run in the reverse mode for 5 seconds,
and then try again.
If you are unable to resolve the problem after trying
the above, get in touch with our customer service.
RECYCLING
Environment protection first!
Your appliance contains valuable materials which can be
recovered or recycled.
Leave it at a local civic waste collection point.
End-of-life electrical and electronic products:
Your appliance is designed to operate for many years. However,
the day you plan to replace it, do not throw it away with normal
household rubbish or in a landfill but take it to a suitable collection
point provided by your local authority (or to a recycling center if
applicable).
Environnemental protection first!
Your appliance contains numerous materials that can be recovered or
recycled.
Take it to a collection point for processing.
EN
13