Closing Force Adjustment; Setting Of Additional Remote Controls; Remote Control Memory Clearing - cherubini Blue Wave RX Einstellanleitungen

B + C
Tn
This system, the only one of its kind, guarantees that
cassette-awnings remain perfectly closed, without
any danger of the canvas suffering excessive traction.
The system works in all kinds of applications,
thanks to the possibility of manually adjusting the
closing force. The Blue Wave RX is factory set to a
closing force of 40 % of the nominal torque (e.g.:
40 % of 50 Nm = 20 Nm). This force can be changed
very easily by the remote control. It can be reduced by
20 % or increased up to 70 %, depending on the desired
result.

SETTING OF ADDITIONAL REMOTE CONTROLS

Up to 15 remote controls can be set, including the light/wind sensor.
Tn: Already programmed remote control
Tx: Additional remote control
A
+ B
Tn

REMOTE CONTROL MEMORY CLEARING

It is possible to delete singly all the memorized remote controls. When the last one is
deleted the motor initial condition is restored. The same applies to the single channels of
a multichannel remote control: just select the channel to cancel.
Tn: Remote control to be cleared
A
+ B
Tn

CLOSING FORCE ADJUSTMENT

A
B
Tn
A
Tn
70 %
40 %
20 %
37
A
B
C
2 sec
B
Tx (2 sec)
B
Tn (2 sec)