Getting Hot Water - SOLAC CE4483 Gebrauchsanleitung

Downloaded by: pd-oliana on 12-08-2022 13:13 CEST
Replace the tank in its housing, ensuring that it
is well fitted.
FILLING OF COFFEE:
Remove the filter holder.
Position the ground chosen coffee filter ((L ó M)
in the filter holder
We recommend using natural toast coffee, as
using roasted coffee may affect the operation
of the machine.
Fill the removable filter with ground coffee (6-7 g
per cup to be prepared).
If you wish to make 1 coffee, use 1 filter coffee
and, fill the ladle (1 spoonful) and take the ca-
pacity of the measuring spoon as the measure
for one coffee until half its capacity.
For 2 coffees, use 2 cups filter (M), and put in
2 spoonfuls.
Next lightly press down the ground coffee with
the back of the spoon.
Fit the filter holder in the appliance once more.
Position the filter holder in the coffee assembly
by inserting the assembly downwards and turn-
ing it from left to right until it locks.
USE
Before connecting the machine, check that the
buttons (F, G) are not pressed, and steam con-
trol (R) is closed
Connect the appliance to the mains.
Turn the appliance on using the on/off switch (F)
The (D) pilot light comes on.
Wait until the pilot light (E) is lighting. It means
right temperature is reached
Place one or two preheated cups at the filter
holder outlet.
Press the coffee switch (G) to the ON position
The coffee infusion will begin to exit. When you
have obtained the desired quantity of espresso
coffee (short or long), come back switch to OFF
position
Once serving has finished, wait a few seconds
and remove the cups with the coffee.
Remove the filter holder and empty the grounds
from it.
Wash the filter holder with running water and
dry it well.
Check that the removable filter is perfectly fitted
into the filter holder.
Fit the filter holder in the appliance once more.
Libro 1.indb 8 Libro 1.indb 8

GETTING HOT WATER:

Put the device in ON situation, pressing the
knob ON/OFF (F)
The Heating indicator light (D) will illuminate in-
dicating that the water is heating up.
Wait Until the pilot light (E) is also highlight-
ed. This situation indicates that the water has
reached the right temperature.
Place A container under the nozzle.
Open The steam control (R), turning him to the
left, counterclockwise
Press The button coffee /water outlet (G)
The Hot water began to come out of the vapor-
izer.
Once obtained the desired amount of hot water,
press the coffee outlet button (G) again, which
stops the pump
Close The turning knob (R) to the right, clock-
wise
OBTAINING STEAM:
The steam is used to foam milk for cappuccino,
and also to heat other liquids.
Turn the appliance on using the on/off switch.
Wait until the pilot light (G) has gone out which
will indicate that the appliance has reached an
adequate temperature for making coffee
For Steam, press the Steam heating button (H)
and continue heating until the steam tempera-
ture has been reached.
The warning light (E) will illuminate indicating
that the water has reached the necessary tem-
perature for generating steam.
Place a recipient under the steam tube.
Open Steam knob (R) anticlockwise
Steam only will begin to exit.
When you have enough, close the control and
remove the recipient.
AUTOOFF FEATURE:
The SOLAC machines are designed to save
energy
To that end, after some minutes from the last
operation, the unit switches to energy saving
mode
To return to normal operation you should just
Switch OFF and Switch ON the connect button
(F)
ONCE YOU HAVE FINISHED USING THE AP-
PLIANCE:
Turn the appliance off, using the on/off switch
(F) to OFF
7/3/22 11:12 7/3/22 11:12