Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
34
INSTALLATION INSTRUCTION
Before using your appliance
To ensure proper electrical connection, follow the recommendations given in the
present manual.
•
Unpack the appliance and visually check that it is not damaged. Do not
connect a damaged appliance. Inform your retailer or point of sale of any
damage. In such a case, keep the packaging.
•
It is recommended that the appliance be allowed to settle for at least 4 hours
before connecting the electrical power supply, so that the compressor fluid
feed is correct.
•
Proper air circulation is necessary to avoid overheating. To ensure sufficient
ventilation, observe the installation recommendations provided.
•
In order to avoid fire risk, wherever possible, ensure that the appliance is
not in contact with walls or with any hot element (compressor, condenser).
Observe the installation recommendations.
•
The appliance should not be placed close to radiators or cooking hot plates or
gas rings.
•
Check that electrical sockets remain accessible when the appliance is installed.
•
Before connecting the appliance to the electrical socket, leave it in position
for 24 hours. This will reduce the possibility of malfunction of the refrigeration
circuit due to transport.
•
Clean the inside using a soft cloth and lukewarm water.
Installation
•
This device should be placed in a dry room with good ventilation.
•
Provide adequate ventilation and do not block the ventilation slots of the unit
to prevent overheating.
•
Place the unit in a location that is stable enough to support the weight of a
filled refrigerator. To ensure the refrigerator is level, adjust the height on the
refrigerator feet.
•
To have the lowest possible energy consumption, do not place the appliance
in the source of heat sources (heater, stove, etc.) and do not expose it to direct
sunlight. Also, avoid placing the device in a very cold room.
•
Insert the power plug of the device into an outlet that is easily accessible
to you. If you have any questions regarding grounding and/or power
consumption, please contact Customer Service or a qualified electrician
directly.
Note: Make sure that the on/off switch of the device and the socket to which it was
connected are still easily accessible after the device has been installed.
Werbung
Inhaltsverzeichnis
