Remove The Trimmer Head; Assemble The Trimmer Head; Assemble The Brush Cutter Blade/ Saw Blade; Remove The Brush Cutter Blade/ Saw Blade - Cramer 2101586 Bedienungsanleitung

1. Line up the slots on the spool cap with the slots on the
trimmer head.
2. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
3. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
4. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
5.5

REMOVE THE TRIMMER HEAD

Figure 18.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
5.6

ASSEMBLE THE TRIMMER HEAD

Figure 17.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
IMPORTANT
You must install the cut-off blade when you use the trimmer
head.
5.7 ASSEMBLE THE BRUSH CUTTER
BLADE/ SAW BLADE
Figure 19.
WARNING
Wear gloves and be careful with sharp edges.
WARNING
Apply the guard to the blade.
WARNING
Use the specified Nylon locknut which is packed with the
blade to assemble the blade. You must change the locknut
after using it for 20 times.
1. Put the meatal rod in the specified angle transmission
hole to fix the trimmer head.
2. Put the brush-cutter blade/saw blade on top of the gear
box. Make sure the blade is in the center.
3. Put the plate above the blade.
4. Put the outer cup above the plate.
English
5. Put the lock-nut above the outer cup.
6. Tighten the lock-nut counter-clockwise with the wrench.
5.8 REMOVE THE BRUSH CUTTER
BLADE/ SAW BLADE
Figure 20.
Apply the guard to the blade.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Loosen the nut clockwise and remove the outer cup.
3. Remove the brush cutter blade/saw blade.
6 TRANSPORTATION AND
STORAGE
6.1

MOVE THE MACHINE

When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
6.2

STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot access the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
7

TROUBLESHOOTING

Problem Possible Cause
The ma- No electrical con-
chine does tact between the
not start machine and the
when the battery pack.
trigger is
pushed.
The battery pack is
depleted.
The lock-out but-
ton and trigger are
not pushed at the
same time.
7
WARNING
Solution
1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
Charge the battery pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.
EN